92 Brocade MLX Series and NetIron XMR Hardware Installation Guide
53-1003821-01
Installing a Brocade MLX-32 router
2
3. Remove the remaining bolts and screws that attach the bottom of the crate to the pallet.
4. Slide the sides, top, and back of the crate backwards as one unit until it clears the pallet.
5. Save the crate (including the shipping panel) in case the router needs to be shipped again.
Installing a Brocade MLX-32 router in a rack
Make sure the rack or cabinet housing the router is adequately secured to prevent it from
becoming unstable or falling over.
Mount the routers you install in a rack or cabinet as low as possible. Place the heaviest router at
the bottom and progressively place lighter routers above.
Because of the weight of a fully loaded Brocade MLX-32 router, it is recommended that you install
the router in a rack before installing any modules and power supplies.
You can install one 32-slot router in a standard 2-post or 4-post 19-inch rack or open frame
cabinet, in either a front-mount position or a mid-mount position. You must provide eight standard
#12-24 pan-head screws to secure the router in the rack. You will need a #2 Phillips screwdriver to
perform this task.
To Next Page
Loading...
Need help?
General
