Brocade Communications Systems MLX Series - Installing a Brocade MLX-32 Router in a Rack

Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide 197
53-1002373-02
Installing a Brocade MLX-32 router
3
FIGURE 137 Removing bolts and screws and the front panel of the shipping crate
3. Remove the remaining bolts and screws that attach the bottom of the crate to the pallet.
4. Slide the sides, top, and back of the crate backwards as one unit until it clears the pallet.
5. Save the crate (including the shipping panel) in case the router needs to be shipped again.
Installing a Brocade MLX-32 router in a rack
DANGER
Make sure the rack or cabinet housing the router is adequately secured to prevent it from
becoming unstable or falling over.
DANGER
Mount the routers you install in a rack or cabinet as low as possible. Place the heaviest router at
the bottom and progressively place lighter routers above.
Because of the weight of a fully loaded Brocade MLX-32 router, it is recommended that you install
the router in a rack before installing any modules and power supplies.