Brocade Communications Systems MLX Series

To Next Page

To Previous Page

Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide 31

53-1002373-02

Router modules

Power supply requirements for Gen-1 2-port or 4-port 10 Gbps Ethernet interface modules

Table 10 lists the power supply requirements for each type of router when installing Gen-1 2-port or

4-port 10 Gbps Ethernet interface modules.

TABLE 10 Power supply requirements for Gen-1 2-port or 4-port 10 Gbps Ethernet interface modules

Router type Number of Gen-1

2-port or 4-port Gbps

Ethernet interface

modules installed

Power supply requirements

MLXe-4 three one 1200W PSU

for 1+1 redundancy, install two 1200W PSU

four two 1200W PSU

for 2+2 redundancy, install four 1200W PSU

MLX-4 and

Brocade NetIron

XMR 4000

four one 1200W PSU

for 1+1 redundancy, install two 1200W PSU

MLXe-8 seven two 1200W PSU

for 2+2 redundancy, install four 1200W PSU

eight three 1200W PSU

for 3+1 redundancy, install four 1200W PSU

Brocade NetIron

XMR 8000

eight two 1200W PSU

for 2+2 redundancy, install eight 1200W PSU

All 16-slot routers sixteen four 1200W PSU

for 4+4 redundancy, install eight 1200W PSU

All 32-slot routers thirty-two four 2400W PSU

for 4+4 redundancy, install eight 2400W PSU

Brocade Communications Systems MLX Series - Page 49