Brookfield DV3T - Page 37

Brookeld Engineering Labs., Inc. Page 37 Manual No. M13-167-A0415
Figure III-13
TIP: If the operator selects “Do not show this message again” within the
Instructionsmessagebox,thenInstructionswillnolongerbedisplayedfor
anytest.ThisconditioncanberesettoallowInstructionstobedisplayed
intheDisplaysectionofUserSettings
.
TIP:Instructionscanbeviewedduringthetestbyselectinginstructions(more/
lessbar)intheViewTestscreen.
Reports:Denehowdatawillbepresentedattheconclusionofthetestandspecifythepathfor
savingdatales.Upontheconclusionofatest,theusercanbepresentedwitheither:a
Graph,Table,MathModel,oranAverageofcollecteddatapoints.OnceintheResults
section,thedownarrow
canbeusedtochangetheview.
PostTestAveragingcanbespeciedaseitherTestAveragingorStepAveraging.Test
Averagingallowsyoutoselectwhichstepfromtheprogram(createdwithPGFlash)is
tobeaveragedanddisplayed.StepAveragingisusedwhenthereisasingleteststep.
SeeSectionIII.10formoredetailrelatingtoDataAveraging.
Thedatapathforsavingdatacanbepreselectedaspartofthetestreport.
TIP: Selectingadatapathcanhelptoorganizedatastorageintheinternal
memoryofDV3T.Bypreselectingthedatapath,operatorsaredirected
toputdatafromspecictestsintospecicareas.
TIP: IfyouselectadatapaththatincludesaUSBFlashDrivelocationandthe
USBFlashDrivehasbeenremoved,anerrormessagewillbedisplayed.
Density: Inputadensityvalueforthesampletobetested.Thisvaluewillbeusedtocalculate
viscosity when kinematic viscosity units have been chosen for display (see Section
V.4.2).