Brother GTX600NB - Page 283

9-12
Error message
Error code Error message Description
Remedy
4400 [Test print data Error]
An error has been detected
in the built-in test print data.
In the event that this error is displayed after
suspending the updating of firmware, please
start the updating operation over from the
beginning.
If the problem persists, please contact your
dealer.
4401 [Test print data Error]
An error has been detected
in the built-in test print data.
In the event that this error is displayed after
suspending the updating of firmware, please
start the updating operation over from the
beginning.
If the problem persists, please contact your
dealer.
4402 [Test print data Error]
An error has been detected
in the built-in test print data.
In the event that this error is displayed after
suspending the updating of firmware, please
start the updating operation over from the
beginning.
If the problem persists, please contact your
dealer.
4500 [Machine Error]
Network-related settings
have been failed.
Press the OK button to clear the error.
Contact your network setup manager and
network administrator.
If the problem persists, please contact your
dealer.
4501 [IP Address Setting Error]
Network-related settings
have been failed.
Press the OK button to clear the error.
Use the maintenance tool to set up a correct
static IP address and subnet mask value once
again.
4502 [Machine Error]
Network-related settings
have been failed.
Press the OK button to clear the error.
Contact your network setup manager and
network administrator.
If the problem persists, please contact your
dealer.
4503 [Machine Error]
Network-related settings
have been failed.
Press the OK button to clear the error.
Use the maintenance tool to set up a correct
static IP address of default gateway once again.
4504 [IP Address Setting Error]
Network-related settings
have been failed.
Press the OK button to clear the error.
Use the maintenance tool to set up a correct
static IP address and subnet mask value once
again.
4505 [Machine Error]
Network-related settings
have been failed.
Press the OK button to clear the error.
4510 [Machine Error]
Network-related settings
have been failed.
Press the OK button to clear the error.
Make sure that the network settings are correct.
Restart the printer and redo the network filtering
settings if the settings are correct.
5010 [PC Data Error]
An error has been detected
in the current print data being
run.
Press the OK button to clear the error.
Create the print data again on the PC to load it
to the printer, and try the print operation again.