Valid from serial number T-code
713962- 403-414, 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual REFLEX RR B/E, RR B/E CC 16- 1
Drive wheel – 3530
General
16- Drive wheel – 3530
16.1 General
The drive wheel consists of a cast rim with a vulcanised tread. When
changing the drive wheel you must ensure that you tighten the wheel
nuts to the correct torque.
On the Reflex truck two different sizes of wheel have been used.
One with the dimensions diameter 310x12 mm and one 350x130 mm.
The smaller wheel (310 mm) is used on B/E1- B/E3.
The larger wheel (350 mm) is used on B/E4 - B/E8.
16.2 Dismantling the drive wheel
• Lift up the truck on blocks so that the drive wheel is off the ground.
• Unscrew the four bolts holding the guard plate.
• Remove the guard plate.
• Unscrew the nuts holding the drive wheel in position.
• Lift off the drive wheel.
16.3 Assembling the drive wheel
• Lift on the new drive wheel.
• Apply MOLYKOTE grease BT number 055-73040 on the wheel bolts.
• Position the spherical washers (1) on the wheel bolts.
• Tighten the wheel nuts (2) to 130 Nm.
• Fit the guard plate.
• Remove the blocks.
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...