T-code Valid from serial number
403-414, 669-671, 716-718 713962-
Date Order number
2005-06-01 218920-040
24- 10 Service Manual REFLEX RR B/E, RR B/E CC © BT Europe AB
Electronic card – 5710
Parameter setting of all parameters
24.5 Parameter setting
of all parameters
Keypad
• Connect the service key to the truck.
Alternatively, a PC running the TruckCom application can be used.
• Enter the driver PIN-code and then depress the green I key on the
keypad so that the electronic card will recieve positive feed, at the
same time push the travel direction selector in the fork direction.
The following functions will scroll across the display:
• Time of day CL
• Parameters P
• Serial number of softwaresoftwarePn
• Operating hours H
• Error codes E
Release the travel direction selector at the desired item.
Use the lift/lowering lever to increase/decrease the value.
The travel direction selector is used for the different adjustment modes.
The display shows the following functions:
- (C) Time of day
- (D) parameters, serial number of software, operating hours and
error codes
The "No." of the address register is displayed on the left side, while the
"value" is displayed on the right side.
Clock
When clock setting is selected, the hours will blink in the display, and
after depressing the travel direction selector, the minutes will blink.
• Use the lift/lowering lever to increase/decrease the value.
• Use the travel direction selector to switch between hours and min-
utes.
Complete programming and store the set value by depressing the red 0
key.
Function Value
hours 09 = 9h
minutes 35 = 35 min
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...