Valid from serial number T-code
713962- 403-414, 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual REFLEX RR B/E, RR B/E CC 38- 5
Battery charger – 8340
Functional description
38.3.9 Display and keyboard
The charger’s panel contains, among others, a display, keyboard and
three LEDs.
• The LEDs show the current charging phase and any errors.
• The display shows different measurement values and the gathered
data. During charging the display shows the normal charging current
and during measurement and resting the battery voltage.
• You can control the displayed information and program the compu-
ter from the keyboard.
Reading of analogue measurement values
You can read off the analogue measurement values during the current
charge on the display. The significance of the codes is shown in the fol
-
lowing table:
•Press * code *.
:
Code The display shows
10 The voltage on the charger’s output (V)
11 Total charging time during the main and post charging
(hh.mm)
12 Recharged ampere-hours (Ah)
13 Charging time with voltage under 2.37 V/cell (hh.mm)
14 Charging time with voltage over 2.37 V/cell (hh.mm)
15 Charging current (A)
16 Mains voltage (VAC)
17 Air temperature around the mother board (°C)
18 Temperature on one of the wound units (transformer in
V2-V3, choke in others) (°C)
19 Temperature on one of the diode heatsinks (°C)
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...