Valid from serial number T-code
713962- 403-414, 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual REFLEX RR B/E, RR B/E CC 24- 15
Electronic card – 5710
Parameter setting of all parameters
24.5.1 Parameter 1
The higher the value entered, the less the steering wheel needs to be
turned to turn the drive wheel. The value 6 provides steering with no
progressive steering, i.e. reduced sensitivity at higher speeds.
24.5.2 Parameter 2
Use this parameter to set the maximum allowed travel speed.
24.5.3 Parameter 3
The lower the value entered, the longer it will take for the truck to reach
maximum speed.
24.5.4 Parameter 4
Use this parameter to set the force applied when the truck brakes, i.e.
when the accelerator pedal is released.
24.5.5 Parameter 5
Use this parameter to set the force applied when the truck brakes when
switching the travel direction and the drive motor is used to brake the
truck.
24.5.6 Parameters 6 and 7
Use these parameters to set the height to which the cab (RR E1–8)
should be tilted up and down to. Both values use the reference height in
the initial setting.
24.5.7 Parameter 11
Use this parameter to set the maximum allowed travel speed when
switch S31 is actuated.
24.5.8 Parameter 12
Use this parameter to adjust the extension and retraction speed of the
mast.
24.5.9 Parameters 13 and 14
Use these parameters to adjust the oil flow to the two optional hydraulic
functions.
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...