Valid from serial number T-code
713962- 403-414, 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual REFLEX RR B/E, RR B/E CC 38- 9
Battery charger – 8340
Functional description
Once all the changes have been made a copy-over can be made with
code 22.
• Press * 22 * 2451 *.
2451 is a safety code to avoid data being changed unintentionally. If
charging is in progress the contactors release during the actual copying
process.
Reading parameters
The program and component circuit boards have the same design irre-
spective of the charger’s rated voltage or current. Values are set by
storing parameters concerning the battery and charger in the parame
-
ter memory (EE-prom). These values are written during final testing of
the device.
NOTE:
There are other parameters that are set at the factory and are not de-
scribed here. Default values are values written during the functions
basic programming. The significance of the register is shown in the
following table:
•Press * register *.
Battery specific parameters
1)
Only applies to program version 1.19 or later.
Register Function (resolution, unit) Default
value
200 Battery capacity, Ah 0
210 Recharging factor, % 15
230 No. of cells 0
220 Current that loads the battery during charg-
ing, 100 mA
0
224 Cold storage operations, 0 = no, 1 = yes 0
215
1)
Start voltage for maintenance charging
pulse, 10 mV/cell.
217
204
1)
Lower statistic level ((25 + (y×5))%)
y=at value between 1 and 15, e.g. ((25 +
(2×5))%)=35%
1
205
1)
Statistic range ((z×2)%)
z=optional value for the required range,
e.g. ((10×2)%)=20%
10
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...