Valid from serial number T-code
713962- 403-414, 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual REFLEX RR B/E, RR B/E CC 39- 1
Control/computer equipment – 8700
General
39- Control/computer equipment –
8700
User manual for TruckCom 3.5 - for “Rider Trucks”
This manual is valid for TruckCom 3.5, program number 182145-008.
39.1 General
TruckCom is a communications program that communicates with
trucks equipped with CAN (Controller Area Network) communication.
The program allows the following functions:
• Downloading the software.
• Displaying and adjusting driver and truck parameters and measure-
ment data. You can also save the parameter values (including val-
ues for measurement data) for later reloading.
• Displaying data for various digital inputs/outputs and analogue data
including voltage, current strength and specific temperatures.
The program is a Windows program run under Windows®
95/98, Windows® XP/2000 and Windows® NT.
39.2 Connection
In order to connect to the truck, a CAN interface of the CPC-PP type
with associated cable is required. The interface is connected to the
printer port on a PC, and the cable must be connected between the
interface and the truck’s CAN connection.
The CAN interface is supplied with current from the truck’s electronics
and is protected from any high currents in the truck in the event of a
fault arising.
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...