T-code Valid from serial number
403-414, 669-671, 716-718 713962-
Date Order number
2005-06-01 218920-040
20- 2 Service Manual REFLEX RR B/E, RR B/E CC © BT Europe AB
Steering angle sensor – 4350
Procedure
20.1.1 Adjustment of the steering angle
sensor
Roughly adjust the sensor to a detection range of ~1.1 mm.
• Measure the supply voltage to the sensor, i.e. connector 810 on the
A5 electronic card.
• Screw the sensor onto the large plate until it touches the right part of
the cog.
• Then unscrew one full rotation.
• Make sure the sensor is mounted with the LEDs set horizontal and
the red LED facing the fork direction.
• Fine-adjust by turning the outer, large plate.
• Measure the voltage on both sensor outputs while the steering
wheel is turning and the gear rotating.
• To achieve a correct on/off switching pulse, the voltage on the sen-
sor outputs, or connectors 210 and 211 on the A5 electronic card,
should be half that of the supply voltage.
• Finally tighten the large nut and the sensor mounting screws.
1,1 mm
1
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...