BT REFLEX RR B7-8C - 26.5 Adjusting the maximum lifting capacity

Valid from serial number T-code
713962- 403-414, 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual REFLEX RR B,E RR B,E CC 26- 13
Hydraulics – 6000
Adjusting the maximum lifting capacity
26.5 Adjusting the maximum lifting
capacity
The hydraulic system must be run warm for approx. 10 minutes when
adjusting the maximum lift capacity so that the correct value is
obtained.
• Extend the reach carriage.
• Lower the forks to floor level.
• Remove the seal on the adjuster screw (A).
• Load the forks with the maximum weight.
The right lift capacity is achieved when the inner guide stops just above
free lift, approx. 10 mm.
• Lower the forks to floor level.
Adjust to the right lift capacity using the adjuster screw (A) on the main
valve.
A = Flow regulation for fork lifting.
B = Flow regulation for fork lowering.
• Loosen the locking nut.
• Screw the adjuster screw (A) outwards to increase the flow.
• Screw the adjuster screw (A) inwards to reduce the flow.
• Lock the locking nut.
Seal the adjuster screw (A).
Model Min. (kg) Max. (kg)
RR B/E1-B/E3 1600 1920
RR B/E1-B/E2 1475 1770
RR B/E3 (Side shift standard) 1475 1770
RR B/E4-B/E6 2000 2400
RR B/E4-B/E6 Side shift 1875 2250
RR B7-B8 (side shift standard) 2500 3000
B
A
https://www.forkliftpdfmanuals.com/