BT REFLEX RR B7-8C - 17.4 Dismantling;assembling the wheel bearings; 17.4.1 265 mm wheel and 300 mm wheel without brakes.; Dismantling the bearing; Assembling bearings

Valid from serial number T-code
713962- 403-414, 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual REFLEX RR B,E RR B,E CC 17- 5
Fork/support arm wheel – 3550.1
Dismantling/assembling the wheel bearings
17.4 Dismantling/assembling the wheel
bearings
17.4.1 265 mm wheel and 300 mm wheel
without brakes.
Dismantling the bearing
• Remove the spacers (1).
• Remove the retainer rings (2).
• Press out the sleeve (3).
• Use a “soft” brass punch or similar to knock out the bearings (4).
Assembling bearings
• Press in the bearings (4). Use an assembly sleeve of the same out-
side diameter as the bearing’s outer ring, 90 mm.
• Check that the sleeve (3) is not damaged.
• Fit one of the retainer rings (2) on the sleeve.
• Press in the sleeve until the retainer ring stops against the bearing.
• Fit the other retainer ring.
• Place the spacers (1) in position on the hub.
https://www.forkliftpdfmanuals.com/