Valid from serial number T-code
713962- 403-414, 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual REFLEX RR B,E RR B,E CC 37- 17
Lifting devices – 7400
Extended forks
37.7 Extended forks
The standard fork can be extended using extended forks, allowing you
to transport bulkier items. When fitting the extended fork, check that it
has been adapted for mounting on a standard truck fork (see informa
-
tion on identification plate). Use only in pairs when the specified fork
dimensions correspond and the truck fork’s length is greater than or
equal to the minimum permitted truck fork length.
NOTE!
Please note that load capacity is reduced once the extended forks are
attached.
NOTE!
The extended fork must not be used if the mounting is not secure, if it
is damaged, dirty or icy. The chamfered underside must face down
-
wards. Daily visual inspection is recommended.
• The extended fork must be regularly maintained, and inspected
once a year.
• If the extended fork’s plate thickness at any spot is less than 3 mm,
it must immediately be replaced.
• If the extended fork shows signs of distortion, cracks or other dam-
age, it must immediately be taken out of service.
• A crack-indication check must be performed using the dye penetra-
tion method.
• Check the function and safety of the locking pin.
To fit the forks, use the following locking pin:
Check that the extended fork is firmly attached, pull on the fork to check
it is secure.
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...