Valid from serial number T-code
713962- 403-414, 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual REFLEX RR B/E, RR B/E CC 28- 1
Hydraulic connections – 6230
General
28- Hydraulic connections – 6230
28.1 General
It is important that hydraulic connections are tightened correctly to give
a sealed and durable connection.
28.2 Tightening torque for hydraulic
connections
28.2.1 Conical connection with O-ring
The nut is screwed by hand down until it stops and is then tightened
either to a torque or to a number of degrees as set out in the table
below. Usually used on the majority of hydraulic hoses on trucks,
Dimension ø
[mm]
Tightening
torque [Nm]
Tightening angle
[°]
6 23 30-45
10 30 30-45
12 50 30-45
15 60 30-45
18 70 30-45
20 80 30-45
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...