BT REFLEX RR B7-8C - 27.2.2 Assembling

T-code Valid from serial number
403-414, 669-671, 716-718 713962-
Date Order number
2005-06-01 218920-040
27- 2 Service Manual REFLEX RR B/E, RR B/E CC © BT Europe AB
Hydraulic pump – 6140
Replacing the hydraulic pump
27.2.2 Assembling
• Fit the hose coupling on the pump unit (13).
• Replace the carrier between the pump and the pump motor (8).
• Replace the pump unit (13) on the pump motor (8).
• Replace both mounting (12) attachments on the pump motor (8).
• Screw a lifting eye into the end of the motor axle and connect it to an
overhead crane.
• Lift the hydraulic pump into the truck while at the same time refitting
the hydraulic hose (10) on the tank (3).
• Tighten the hose clamp.
• Fasten the two pump mountings (12) to the chassis using the bolts
(5).
• Unscrew the lifting eye.
• Refit the hydraulic hose (9) and the temperature/speed measuring
contacts (6) and power cables (7).
• Fill the hydraulic tank (3) with 48 litres of new oil.
8
13
https://www.forkliftpdfmanuals.com/