Valid from serial number T-code
713962- 403-414, 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual REFLEX RR B/E, RR B/E CC 39- 5
Control/computer equipment – 8700
Function for connection
39.4 Function for connection
In order to connect the PC to the network, select the "Scan units" func-
tion. This can be done using the <Nodes | Scan units> menu or using
tool button [Scan nodes].
This must be done when the truck is energised and in normal drive
mode. The program now carries out a check and sets CAN interface. A
diagnosis is also carried out to check which units are connected to the
system. The results of this diagnosis are shown in the “Node” window.
39.5 Function for disconnecting
In order to disconnect from the network, select the “Disconnect” func-
tion. This can be done using the <Nodes | Set PC off-Line > menu or
with the tool button [Set PC off-Line].
The CAN interface then resets and it is possible to disconnect the CAN
cable if required. The aim is to be able to connect to another truck with
-
out needing to close the program.
39.6 Function for program downloading
In order to download a new program to one of the nodes, select the
"Download" function. This can be done using the <Tools | Download
software... > menu or using tool button [Download].
123456
Type
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...