T-code Valid from serial number
403-414, 669-671, 716-718 713962-
Date Order number
2005-06-01 218920-040
31- 2 Service Manual REFLEX RR B,E RR B,E CC © BT Europe AB
Free lift cylinder – 6620
Dismantling
31.3 Dismantling
• Remove the feeder pipe on the free lift cylinder.
• Plug the free lift cylinder.
• Remove the venting hose.
• Loosen the mounting bolts on the top side of the free lift cylinder.
• Lift up the intermediate runner using an overhead crane so that the
twin hose and cable slacken off.
• Remove the twin hose and cable from the hose reels on the free lift
cylinder.
• Block up under the fork yoke.
• Lower the overhead crane so that the fork yoke rests on the block
and the free lift chain slackens off.
• Strap together the chains so that they do not slide out of the upper
chain sprockets.
• If there is a chain guard, this should be removed from the bracket.
• Remove the inner split pin on the free lift chain pin.
• Remove the free lift chain pin.
• Lift off the free lift chain from the free lift cylinder.
• Remove the chain adjuster from the free lift cylinder.
• Secure a lifting strap around the free lift chain bracket by the end of
the free lift piston and a lifting strap around the free lift cylinder (see
diagram).
• Secure the lifting strap in an overhead crane.
• Remove the mounting bolts on the top side of the free lift cylinder.
• Lower the free lift cylinder.
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...