Valid from serial number T-code
713962- 403-414, 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual REFLEX RR B/E, RR B/E CC 25- 103
Keypad
Programming
25.4.2 Driver PIN-codes
The table shows the driver PIN-codes that is programmed as standard.
Theese can be activated for usage or changed according to the driver’s
whishes.
One or more of theese block can be activated.
One driver profile is guilty for all blocks in the same column and can be
programmed according to the chapter “Displaying and programming” in
chapter “Electronic card”. See parameters 1-7.
To enter programming mode:
• Connect the service CAN-key
• Designate 341671 and depress the green pushbutton.
Pro-
file 0
Pro-
file 1
Pro-
file 2
Pro-
file 3
Pro-
file 4
Pro-
file 5
Pro-
file 6
Pro-
file 7
Pro-
file 8
Pro-
file 9
Block 0 0000 0001 0002 0003 0000 0000 0000 0000 0000 0000
Block 1 5421 7901 1437 3731 1049 9439 7265 1322 2869 1574
Block 2 1787 4854 2907 9175 5799 1490 3031 7392 5622 5023
Block 3 4659 3174 1026 3815 6703 1179 5152 7514 5668 3215
Block 4 9197 7110 5477 3846 9491 5918 8222 6923 8139 7025
Block 5 2549 6276 9879 9658 1690 4042 5201 9807 4332 9715
Block 6 7474 4142 8620 3754 8432 8788 7430 1948 2595 8527
Block 7 1930 1482 7135 2395 7365 7092 4611 2831 4185 6067
Block 8 2876 4731 1022 5377 3257 7334 9009 7881 8843 7436
Block 9 3242 3162 5878 2828 1910 6907 2136 5730 2957 7691
Programming Function Remark
1 + green pushbutton Return to factory settings
2 + block nr + green pushbutton Driver parameters in the block
can be used
3 + block nr + green pushbutton Driver parameters in the block
can not be used
4 + block nr + profile nr + NNNN + green
pushbutton
Programming of new driver PIN-
code
NNNN = Driver PIN-
code
5 + TT + green pushbutton Programming the close-down
time for the truck, after last
usage.
TT = 01-20 minutes.
00 = 4 timmar
Standard = 20 min-
utes
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...