Valid from serial number T-code
713962- 403-414, 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual REFLEX RR B/E, RR B/E CC 24- 43
Electronic card – 5710
Warning Codes without registration
Drive motor's pulse transducer bearing, U11
1. Check the cables to U11.
- Remove connection X27.
- Check that cable 11 is intact between X27 and terminal 4 on A1.
- Check that cable 10 is intact between X27 and terminal 3 on A1.
- Check that cable 12 is intact between X27 and terminal 5 on A1.
- Check that cable 13 is intact between X27 and terminal 6 on A1.
- Also check the connector pins on the terminals for play and oxidi-
sation.
- If the cables are okay, replace the transducer bearing U11.
2. If the fault remains, replace A1
Code 43
Description Incorrect number of pulses from the drive motor's
pulse transducer bearing
Error mode General error
Error cause 1. Faulty sensor/wiring.
2. Defective drive regulator.
Comments
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...