15 – 14 Repair Manual RRE140/160/180/200/250 © BT
Mast/Lift system 7000
Main mast 1.6-2.5 t (7100)
T-code Valid from serial number Date Publication No.
815, 816 6051502 2008-08-21 261828-040
8. Screw in the screws (a) and their washers into the bottom bracket.
9. Measure the incline to the rear and shim as needed. This should
nominally be 2 shims, or 90° ± 10‘.
10. Engage the screws (a), but do not use a torque wrench to tighten
them.
11. Adjust the lateral incline by loosening the screws (c) on the eccen-
tric cam locking rings (d).
12. Now turn the eccentric cams until the correct lateral incline is
achieved, in other words, 90° ± 6‘.
IMPORTANT!
The eccentric cams must not be turned making the large level surfac-
es face inwards in the cups on the mast attachment in the reach car-
riage.
13. Check the incline to the rear (90° ± 10‘) once more, and add shims
as needed.
a
a
c
d
To Next Page
Loading...
