18
Assembly
7. ASSEMBLY
7.1. Safety instructions
WARNING
Risk of injury due to non-conforming assembly.
• The device must only be assembled by qualified and skilled staff with the appropriate tools.
Risk of injury due to unintentional switch on of power supply or uncontrolled restarting of the
installation.
• Avoid unintentional activation of the installation.
• Guarantee a set or controlled restarting of the process subsequent to any intervention on the device.
7.2. Unscrewing the cover
NOTE
The tightness of the transmitter is not guaranteed when the cover is removed.
• Prevent the projection of liquid inside the housing.
The transmitter may be damaged if a metal component comes into contact with the electronics.
• Prevent contact of the electronics with a metal component (screwdriver, for example).
→ To unscrew the cover, use your hand or a tool which can be used as a
lever, taking care not to scratch the glass.
→ Turn the cover until fully unscrewed.
Fig. 7 Unscrewing the cover
English
Type 8202 ELEMENT
To Next Page
Loading...
Need help?
General
