The Cadex analyzer can be programmed with any combination of service functions
to suit special battery needs. The 10 pre-programmed service programs combine
discharge, charge, recondition, and resistance test to achieve results as required.
Basic Programs
The basic programs include Auto, Charge and Prime. Each program performs
functions for different purposes:
*
If the voltage drops below the level required by the processor within the
Smart Battery, information can be lost. In some cases, this can cause the
battery to become non-operative.
5
Battery Service Programs
21
Function Use
Auto Exercises batteries to maintain
optimum performance. If the Target
Capacity cannot be reached,
recondition is applied.
Restore batteries affected by "memory".
Routine battery maintenance.
Identify marginally performing batteries.
Service batteries in unknown condition.
Verify battery condition for warranty
claim.
Charge Applies fast charge. No capacity
readings are taken and no discharge
is applied.
Fast charge.
Topping up of partially discharged or
partially used batteries.
Prime Repeatedly cycles battery until
maximum capacity is reached. If
capacity improvement is more than 5%
over previous reading, an additional
cycle is applied.
Prepare new batteries for field use.
Condition batteries that have been in
storage. Warning: Do not store Smart
Batteries in discharged state.*
To Next Page
Loading...
