Cadex C7000 - Specialty Programs

Specialty Programs
Specialty programs include OhmTest, Runtime, Self-Discharge, Life-Cycling,
Discharge Only, Extended Prime, and 4 programmable Custom Programs.
22 C7000 & 7000ER Battery Analyzer V3.5
Function Use
OhmTest Tests internal resistance against the
user definable Resistance Threshold.
Passes or Fails the battery.
Check if the battery is in good condition.
Determine if the battery requires to be
further analyzed.
Runtime Measures length of time a battery can
provide a given current and remain
above its End of Voltage. Runtime
Cycles are editable.
Tests runtime of batteries for wireless
communications equipment.
Self-
Discharge
Reads fully charged battery capacity,
recharges and reads the capacity
again after a user definable wait
period. If the second reading is lower
by 30% or more, the battery is failed.
Identify high self discharge on batteries
that otherwise may have good capacity
readings.
Life-
Cycling
Continuously cycles battery until
capacity drops below Target Capacity.
Displays initial and final capacity,
OhmTest result and self discharge
readings (if self discharge is included).
Verify battery life cycle.
Estimate performance time.
Discharge
Only
Discharges a battery to its End of
Discharge voltage.
Determine residual capacity of battery.
Prepare batteries for storage. Warning:
Do not store Smart Batteries in
discharged state (See * on p.21)
Determine battery performance under
load.
Extended
Prime
Applies a 16 hour trickle charge,
followed by cycling to obtain peak
capacity.
Recommended for new batteries or
batteries in extended storage.
Custom
1, 2, 3, 4
Fully programmable by the user. See
Custom Programs.
Accommodate special needs.