82 C7000 & 7000ER Battery Analyzer V3.5
Shock Hazard
The C7000/C7000ER Battery Analyzer contains high-voltage circuits, and can pose a
shock hazard when the upper cover is removed.
Do not attempt to perform any service
procedures on the analyzer other than replacement of the fuses or internal backup battery.
" Use the analyzer only as specified in the documentation. Other uses may impair
the protection provided by the unit.
" Use only a grounded AC outlet to power the analyzer.
" Before attempting any internal service, remove all batteries from the battery stations,
turn the analyzer off, and disconnect the power cord from the wall socket. Wait a few
minutes (30 minutes for the C7000ER) before opening the cover.
" Replace fuses only with fuses of the same type and rating.
" Replace the internal backup battery only with the same type. Observe the correct
polarity when installing the backup battery. Discard the used battery according to the
battery manufacturer’s instructions.
To Next Page
Loading...
