Cadex C7400 User Manual

The analyzer goes through the first phase, then follows the paths prescribed by the
IF, THEN, and ELSE statements in the test cycle of each phase.
Cycle 1 and Cycle 2
There are seven different actions that can be performed as Cycle 1 or Cycle 2 of
phases 1 through 5.
Action Description
Skip Cycle Skips the cycle and goes to the next cycle or the TEST
statement.
Discharge Time
(for 000:00:00
at 100%)
Discharges the battery for the specified time period
(hhh:mm:ss)* at the discharge rate set in the
extended C-code.
A setting of 50% gives a discharge current that is
50% of the C-code discharge rate (see Discharge
Rate, page 52).
Charge Time
(for 00:00:00
at 100%)
Charges the battery for the specified time period (in
hhh:mm:ss format)* at the charge rate set in the
extended C-code.
Recondition Time
(for 000:00:00)
Reconditions (deep discharges) the battery for the
specified time period (hhh:mm:ss)* at the recondition
discharge rate set in the extended C-code.
This cycle is skipped for SLA, Li-Ion and Li-Ph
because these chemistries cannot be reconditioned.
This cycle can be applied only after a discharge
cycle.
Trickle-Charge Time
(rest for 000:00:00)
Charges NiCd and NiMH batteries for the specified
time period (hhh:mm:ss)* at the trickle-charge rate
set in the extended C-code.
This cycle is skipped for SLA, Li-Ion and Li-Ph.
* If the default time period of 000:00:00 is used, the analyzer services the battery according to end-of-charge,
end-of-discharge or end-of-recondition settings in the extended C-code. The maximum allowable is
200:59:59.
101

Cadex C7400 Specifications

General

Brand	Cadex
Model	C7400
Category	Measuring Instruments
Language	English