5. Press or to scroll to YES to accept changes and press ENTER.
6. Press ESC twice to return to the global display.
Note This option is not the same as setting the battery service counter to 0.
When the service counter is set to 0 using the SET SERVICE COUNTER option,
it is disabled. When this option is used to clear the battery service counter,
the service counter is restarting from 0.
To display the number of batteries serviced
This option displays both the total number of batteries serviced and the number of
batteries serviced in a session (a session is ended when the service counter is
cleared).
1. From the global display, press FN, and then press 5.
2. Press ESC to return to the global display.
Connecting to BatteryShop or a Printer
The Cadex analyzer has a RS232 DB-9-pin female serial port to connect to a label
printer or computer. The USB port can only be used to connect to a PC. Other
devices may work with the Cadex analyzer but they are not guaranteed to do so.
Cadex is not responsible for any issues arising from using any printing devices not
sold by Cadex.
Connecting to BatteryShop
To set the analyzer up for BatteryShop, do the following:
Connect the cable provided with BatteryShop to the USB port or serial port on
the analyzer.
Change the analyzer from STANDALONE mode to BATTERYSHOP mode: Press FN
and then press 9 and select Enabled.
Press ENTER to save the settings.
71
To Next Page
Loading...
Need help?
General
