Advanced Programs
Advanced programs include OhmTest; Runtime; Self-Discharge; Life-Cycling;
Discharge Only; Extended Prime; Q-Learn (QuickLearn); Learn; Boost and the four
programmable custom programs. Unlike basic programs, some advanced
programs have settings that can be edited.
Program Does this Is used for this
Self-
Discharge
Reads fully charged battery
capacity; recharges and reads
the capacity after a
programmable wait period.
Identifying batteries that may have
good capacity but have high self-
discharge.
Life-Cycle A destructive test:
Continuously cycles battery
until capacity drops below
target capacity. Displays initial
and final capacity, OhmTest
result.
Verifying battery life cycle. For
example, take a sample of
batteries to determine the Life
Cycle of an entire batch of
batteries.
Estimating performance time.
Discharge
Only
(DCHOnly)
Discharges a battery to its
end-of-discharge voltage.
Determining residual capacity of
battery.
Preparing batteries for storage.
Determining battery performance
under load.
Extended
Prime
Applies a 16-hour trickle
charge, followed by cycling to
obtain peak capacity.
Preparing new batteries or
batteries that have been in
extended storage for use.
OhmTest Tests internal resistance.
Passes or fails the battery
based on the target
resistance.
Checking battery condition.
Determining if the battery needs to
be analyzed further.
Runtime Simulates field application
with three adjustable load
currents and time intervals.
Testing battery runtime for various
equipment.
Cadex Electronics Inc. C7000-C Series Battery Analyzers .
30
To Next Page
Loading...
Need help?
General
