Cadex C7400 - Setting up the Data Log

Setting up the Data Log
To log data to a computer, connect the Cadex analyzer to the serial port of a
computer (see Connecting to BatteryShop or a Printer, page 71), set the Cadex
analyzer to log data, and set up a program to read the data from the serial port.
The procedure outlined here assumes Microsoft’s HyperTerminal communications
program is used, which comes with most versions of Microsoft Windows; however,
any compatible communications program that can read data through the computer
serial port can be used.
To set the Cadex analyzer to log data to a computer
1. From the global display, press MENU.
2. Press  or  to scroll to SYSTEM SETUP and then press ENTER.
3. Press  or  to scroll to SERIAL PORT DEVICE and then press ENTER.
4. Press  or  to scroll to TERMINAL and then press ENTER.
5. Press  or  to scroll to YES to accept changes and press ENTER.
6. Press  to scroll to SERIAL PORT SETTINGS and then press ENTER.
7. Pressing  or  to move the cursor between options and  or  to
scroll through available settings, enter these serial port settings:
• baud rate: 9600
• handshake: none
• data bits: 8
• stop bits: 1
• parity: none
8. Press ENTER.
9. Press  or  to scroll to YES to accept changes and press ENTER.
10. Press ESC twice to return to the global display.
Cadex Electronics Inc. C7000-C Series Battery Analyzers .
96