c) Press or to scroll to the advanced program to run.
d) Press to select the program and move to TARGET.
At any time from this point, press ENTER to save the changes.
5. Press or or use the keypad to enter the required target capacity
(see Target Capacity, page 49).
6. Press to move to TYPE.
7. Press or to scroll to the appropriate battery chemistry for the C-
code.
8. Press to move to VOLTS.
9. Press or or use the keypad to enter the voltage (VOLTS) of the
battery to be serviced (see Battery Voltage (Volts), page 49).
10. Press to move to mAh.
11. Press or or use the keypad to enter the battery capacity in
milliampere hours (mAh) (see Battery Rating, page 50).
12. Press ENTER.
13. To leave the extended C-code parameters at the default settings:
a) Press ENTER again.
b) Press or to scroll to YES to accept changes and press
ENTER.
To edit the extended C-code parameters (not usually required):
a) Press .
b) Edit the extended C-code settings (see Extended C-code
Parameters, page 51).
Press or to move between C-code settings.
Press or or use the keypad to change the settings as required.
c) Press ENTER.
63
To Next Page
Loading...
Need help?
General
