Canon EOS-7D - Auto Exposure Bracketing (AEB)

109
By changing the shutter speed or aperture automatically, the camera
brackets the exposure up to ±3 stops in 1/3-stop increments for three
successive shots. This is called AEB.
* AEB stands for Auto Exposure Bracketing.
1
Select [Expo. comp./AEB].
 Under the [2] tab, select [Expo.
comp./AEB], then press <0>.
2
Set the AEB amount.
 Turn the < 6 > dial to set the AEB amount.
 You can set the exposure compensation
amount with the <
5 > dial. If AEB is
combined with exposure compensation,
AEB will be applied centering on the
exposure compensation amount.
 Press <0> to set it.

When you exit the menu, < h > and the AEB
level will be displayed on the LCD panel.
3
Take the picture.
 Focus and press the shutter button
completely. The three bracketed shots will be
taken in this sequence: Standard, decreased
exposure, and increased exposure.
 Follow steps 1 and 2 to turn off the AEB amount display.
 AEB will be canceled automatically when you set the power switch
to <2> or when the flash is ready to fire.
h Auto Exposure Bracketing (AEB)N
AEB amount
Canceling AEB
 If the drive mode is set to <u>, you must press the shutter button three
times. When <o> or <i> is set and you hold down the shutter button
completely, the three bracketed shots will be taken continuously. Then
the camera will stop shooting. When <Q> or <k> is set, the three
bracketed shots will be taken continuously after a 10-sec. or 2-sec. delay.
 Neither flash nor bulb exposures can be used with AEB.