222
3 Custom Function SettingsN
C.Fn I: Exposure
C.Fn I -1 Exposure level increments
0: 1/3-stop
1: 1/2-stop
Sets 1/2-stop increments for the shutter speed, aperture, exposure
compensation, AEB, flash exposure compensation, etc. Effective when
you prefer to control the exposure in less fine increments than 1/3-stop
increments.
C.Fn I -2 ISO speed setting increments
0: 1/3-stop
1: 1-stop
C.Fn I -3 ISO expansion
0: Off
1: On
For the ISO speed, “H” (equivalent to ISO 12800) will be selectable.
However, if [8C.Fn II -3: Highlight tone priority] is set to [1: Enable],
“H” cannot be set.
C.Fn I -4 Bracketing auto cancel
0: On
The AEB and WB-BKT settings will be canceled if you set the power
switch to <2> or clear the camera settings. AEB will also be canceled
when the flash is ready to fire.
1: Off
The AEB and WB-BKT settings will be retained even when the power
switch is set to <2>. (When the flash is ready, AEB will be canceled.
However, the AEB amount will be retained in memory.)
The exposure level will be displayed in the viewfinder and on the LCD
panel as shown below.
To Next Page
Loading...
