124
Using Wireless FlashN
This shows the most basic setup
for fully-automatic wireless flash
with one Speedlite.
Steps 1 to 3 and 6 to 8 apply to
all wireless flash shooting.
Therefore, these steps are
omitted in the other wireless
flash setups explained on the
following pages.
On the menu screens, the <
0
>
and <
1
> icons refer to the external
Speedlite, and the <
3
> and <
2
>
icons refer to the built-in flash.
1
Press the <I> button to pop-up
the built-in flash.
For wireless flash, be sure to pop-up
the built-in flash.
2
Select [Flash control].
Under the [1] tab, select [Flash
control], then press <0>.
3
Select [Built-in flash func. setting].
Select [Built-in flash func. setting],
then press <0>.
4
Select [Flash mode].
For [Flash mode], select [E-TTL II],
then press <0>.
Fully Automatic Shooting with One External Speedlite
80
o
Approx. 7m
(23.0ft.)
Approx.
5m (16.4ft.)
Approx.
7m
(23.0ft.)
Approx. 10m
(32.8ft.)
To Next Page
