128
Using Wireless FlashN
[1 (A:B)] Multiple slave units in multiple groups
Divide the slave units into
groups A and B, and change
the flash ratio to obtain the
desired lighting effect.
Refer to your Speedlite’s
instruction manual to set one
slave unit’s slave ID to A
(Group A) and the other
slave unit’s ID to B (Group
B) and position them as
shown in the illustration.
1
Set [Firing group] to [1 (A:B)].
2
Set the desired flash ratio and
shoot.
Select [A:B fire ratio] and set the
flash ratio.
A B
80
o
Approx. 7m
(23.0ft.)
Approx.
5m (16.4ft.)
Approx.
7m
(23.0ft.)
Approx. 10m
(32.8ft.)
The 8:1 to 1:1 to 1:8 flash ratio is equivalent to 3:1 to 1:1 to 1:3 stops (1/2-
stop increments).
To Next Page
Loading...
