Canon imageCLASS LBP162dw - Page 56

● When the ne
xt screen is displayed, follow the instructions on the screen.
*
When you select the [De
vice Type], select [Canon Network Printing Device with P9100] under [Standard].
5
Click [Finish].
6
Click [Close].
Changing the port type or number
If the printing pr
otocol (LPD or RAW) has been changed on the machine side (
Conguring Printing
Pr
otocols and WSD Functions(P. 47) ) or the port number has been changed (
Changing Port
Numbers(P
. 157) ), the corresponding settings on the computer must also be congured. This operation is
not needed for WSD ports.
MFNP port
1
Click [Congure Port].
2
Under [Protocol Type], select [RAW] or [LPR], and change the [Port Number].
3
Click [OK].
Standard TCP/IP port
1
Click [Congur
e Port].
2
Under [Protocol], select [Raw] or [LPR].
Setting Up
51