Service Mode > NETWORK GR.
BUFFER LIMIT Setting of PSS buffer acquisition limit
Detail To limit/clear the limit on the acquisition of PSS buffer.
Adj/Set/Operate Method
1) Select the item, and then press OK key.
2) Turn OFF/ON the main power switch.
Caution
The buffer acquisition limit is a setting to assign certain limit on the acquisition of buffer space for
non-active jobs. To secure buffer space for non-active jobs, one has to wait until more than half
the buffer space becomes available. Also, half of the buffer space is always left available for active
jobs until these active jobs are read.
Setting this item to ON clears the above-mentioned buffer acquisition limit and immediately
provides buffer space to non-active jobs as long as there is space available in the buffer.
Setting this item to ON prevents from simultaneously receiving jobs in parallel from multiple ports
(I/F). Make sure to also configure the following settings.
- Enable the job serialization function.
- Configure not to use I/F’s except for the one in use.
- Configure not to use PDL’s except for the one in use.
Display/Adj/Set Range
Off/On
On: Clear the buffer acquisition limit
Off: Limit the buffer acquisition
Default Value
Off
Related Service Mode
NETWORK GR. > JOB SERIALIZE
Additional Functions
Mode
Setup > Interface > Interface Selection
Setup > Print Mode > Auto Mode Selection
MIB CHARGECOUNT Setting of MIB collection counter
Detail To set the range of counter data that can be obtained as MIB (Management Information Base).
Adj/Set/Operate Method
1) Select the item, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range
ALL ACCESS/DISP ACCESS/NON ACCESS
ALL ACCESS: Obtain data for all the billing counters
DISP ACCESS: Obtain data for the displayed counter only
NON ACCESS: Unable to obtain data for any billing counter
Default Value
ALL ACCESS
WOLtrans Setting of sleep recovery protocol
Detail To set recovery from sleep mode.
Adj/Set/Operate Method
1) Select the item, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range
1 to 3
1: Recover from sleep by WSD, and not recover from sleep by the old utility using the broadcast
packet
2: Recover from sleep by WSD, and not have the function to recover from sleep by the old utility
using the SNMP search broadcast packet
3: Recover from sleep by the old utility, and not recover from sleep by WSD
Supplement/Memo
WSD (Web services on devices): a protocol that regulates the procedure to easily link and use
various devices connected to the network
PROXYRES ON/OFF of proxy response
Detail To set whether the proxy server responds (on behalf of the internal network) to an external network.
Adj/Set/Operate Method
1) Select the item, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range
Off/On
Off: No proxy response
On: Proxy response
Default Value
On
9. Service Mode
227
To Next Page
Loading...
