Service Mode > NETWORK GR.
EAPOL_WT Wait time setting for response to EAPOL packet
Detail To set the wait time for response (or the next request) to EAPOL packet sent by the device.
Adj/Set/Operate Method
1) Enter setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range
10 to 120
Unit
Second
Default Value
30
GCP-URLC ON/OFF of connection destination setting for cloud print
Detail To enable/disable the changing from remote UI of connection destination URL for cloud print.
Adj/Set/Operate Method
1) Select the item, and then press OK key.
2) Turn OFF/ON the main power switch.
Caution
Can change the setting from Remote UI > Settings/Registration > Preferences > Network > Google
Cloud Print Settings > Edit Basic Settings > Connection Destination.
Display/Adj/Set Range
Off/On
On: Can change (display)
Off: Cannot change (hide)
Default Value
Off
FTP MODE Default operation mode setting for FTP print
Detail To set the default operation mode for FTP print. Switch between ASCII mode and BIN mode
according to user environment.
Display/Adj/Set Range
MODE0/MODE1
MODE0: ASCII mode
MODE1: BIN mode
Default Value
MODE0
DHCP NACK SW ON/OFF of retries at reception of DHCP NACK
Detail To set the behavior upon receiving DHCP NACK.
Adj/Set/Operate Method
1) Select the item, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range
Off/On
Off: No retries
On; Retries
Default Value
Off
■ E-RDS
Service Mode > NETWORK GR. > E-RDS
E-RDS SWITCH ON/OFF of Embedded-RDS
Detail To set the use/no use of Embedded-RDS function.
Adj/Set/Operate Method
1) Select the item, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range
Off/On
Off: Not use Embedded-RDS
On: Use Embedded-RDS
Default Value
On: Except for China
Off: China
9. Service Mode
228
To Next Page
