Service Mode > NETWORK GR.
Service Mode > NETWORK GR. > IPSEC SETTING
IKEINTVL Setting of IKE retry interval
Detail To set the IKE retry interval (sec.).
Adj/Set/Operate Method
1) Enter setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range
1 to 30
Unit
Second
Default Value
5
SPDALDEL ON/OFF of initialization at next startup
Detail To set whether to initialize policies at next startup.
Setting this value to “1” deletes all the registered policies at the next startup to initialize policies.
The device refers to this setting value every time it starts up and processes initialization if set to
“1.” Return this value to "0" after initialization is complete. Use this item in emergency case where
policies are inconsistent.
Adj/Set/Operate Method
1) Select the item, and then press OK key.
2) Turn OFF/ON the main power switch.
Caution
Be sure to return this value to"0" after initialization is complete.
Display/Adj/Set Range
0/1
0: Not initialize
1: Initialize
Default Value
0
IPSDEBLV Level setting for IPsec logs
Detail To set the debug level for IPsec.
Adj/Set/Operate Method
1) Select the item, and then press OK key.
2) Turn OFF/ON the main power switch.
Caution
Since IPsec operates by a different process from the main program, log information is not kept in
the Sublog Board.
Therefore, change the value when obtaining the IPsec log.
The setting is enabled after restart, and this value becomes"0" internally after restart.
When this log is enabled, a file named "/APL_LOG/ipsec/ipseclog.txt" is generated, in which the
log information is stored. However, this file is cleared when the power is turned ON and then OFF.
Display/Adj/Set Range
0 to 10
0: Not keep logs
1 to 3: Log level 1 to 3, fatal error info
4 to 6: Log level 4 to 6, warning info
7: Log level 7, important log info
8 to 10: Log level 8, all logs
Default Value
0
9. Service Mode
231
To Next Page
