Chapter 7
7-31
- Press [OK] key, and "=" will appear and the initializing process will begin.
[NO]: Do not initialize the e-RDS setting. Default value is [NO].
[YES]: Initialize the e-RDS setting.
6) Displaying the CA Certificate Information [VALIDITY]
For the secure communication between the device (e-RDS) and the UGW, an authentication technology from a certification authority is used. A license has been
issued from the certification authority. For this reason, the devices are shipped with the CA (Certificate Authority) certificate enabled in advance to prove the license
obtained.
Therefore, usually, the setup is not necessary.
To confirm that this CA certificate is valid or how long it will be valid, you can display the expiration date of the CA certificate information.
(1) In service mode, referring to the "Service Mode Menu Tree", go to [VALIDITY] menu using key and key.
F-7-42
(2) Press key, and the expiration date of the CA certificate will be displayed.
F-7-43
- Press key to exit the CA certificate expiration date display screen and go back to the top of [VALIDITY] menu.
* If the CA certificate is deleted, the screen below will appear.
F-7-44
- Press key to exit the CA certificate expiration date display screen and go back to the top of [VALIDITY] menu.
7) Deleting the CA Certificate [CA-KEY]
For the secure communication between the device (e-RDS) and the UGW, an authentication technology from a certification authority is used. A license has been
issued from the certification authority. For this reason, the devices are shipped with the CA (Certificate Authority) certificate enabled in advance to prove the license
obtained.
The device (e-RDS) uses this CA certificate to communicate with the UGW, thus CA must not be deleted.
Therefore, usually, the setup is not necessary.
* If you delete the CA certificate under a special instruction, perform the following procedure.
(1) In service mode, referring to the "Service Mode Menu Tree", go to [CA-KEY] menu using key and key.
F-7-45
(2) Choose between YES/NO using and keys, and press [OK] key to set.
F-7-46
- Press [OK] key, and "=" will appear and the initializing process will begin.
[NO]: Do not delete the CA certificate. Default value is [NO].
[YES]: Delete the CA certificate.
VALIDITY
CA -CERTI FI CATE
YYYY/ MM/ DD
VALIDITY
NOT I NSTAL L ED
VALIDITY
NO
CA- KEY
=YES
CA -KEY
To Next Page
Loading...
Need help?
General
