Canon MV430 - Page 111

4. Select the desired setting.
♦ Your currently recording image is combined with the pre-recorded still
image.
5. Select MIX LEVEL.
6. Adjust the mix level.
• Turning the selector dial upwards adjusts to the right and turning
downwards adjusts to the left.
7. Close the menu.
* CARD MIX flashes in the display.
On/Off
8. P ress the card MIX button.
• CARD MIX stops flashing.
• Your currently recording image is combined with the pre-recorded still
image.
• Each time you press the card MIX button, your selection is activated
(display lights continuously) or deactivated (display flashes).
For a moving image
1. Press the start/stop button to start and stop recording.
• The combined images are recorded onto the cassette.
For a still image
1. Press the PHOTO button halfway down and hold it.
• O flashes white in the display as the camcorder adjusts the focus and it is
displayed continuously as a green mark when the camcorder is ready to take
the image.
2. Press the PHOTO button fully down to record the image to the
cassette.
• O disappears from the display.
• The combined images are recorded onto the cassette for approximately 6
seconds.
[D Notes:
• If you change the position of the POWER switch or move the program selector
from [0 to □ Easy Recording mode, select your still image for Card Mix again.
• When setting Card Mix, you must carry out steps 1 to 4.
Ill
Using
a
Memory
Card