Canon MV430 - Page 131

B The image cannot be erased.
You are using an unformatted
memory card. Format the card
(mii5).
The image is protected (CQ 106).
You are using an SD Memory Card
and it is set for erasure prevention.
Change the position of the protect
switch.
Miscellaneous
__
Problem
B The wireless controller doesn’t
work.
B The power indicator is flashing.
B The camcorder malfunctions.
B The DV cable is connected
correctly, but there’s nothing in
the display.
B The camcorder becomes warm
during use.
]
______J
Cause and/or what to do about it
• The remote sensor mode is set to
OFF((i®D in the menu (0346).
• The remote sensor modes of the
wireless controller and the camcorder
itself are different ( CO 46).
• The batteries are dead or not inserted.
• Check the screen displays (CO 136).
• External interference may cause the
camcorder’s microprocessor to
malfunction temporarily. If random
letters appear in the display or if
normal operation is interrupted,
remove and then replace the power
source.
• Remove the cable and then reconnect
it or turn the power off and back on
again.
• This is not a malfunction.
131
Additional
Information