Carrier TRANSICOLD Vector 8500 User Manual

62-11640 8–14
Figure 8.14 Condenser and Radiator Assemblies
1. Radiator Frame Assembly
2. Radiator Mounting Bracket
3. Radiator
4. Condenser Frame Assembly
5. Radiator Frame Mounting Bolts
8.5.15 Water Pump V-Belt
WARNING
!
Beware of moving poly V-belt.
WARNING
!
When working with belts, beware of
pinch points.
Figure 8.15 Water Pump V-Belt
The water pump v-belt is driven by a sheave on the
engine crankshaft. Frayed, cracked or worn belts must
be replaced. This belt requires no tension adjustment.
To Replace the Poly V-belt:
1. Ensure the unit will not start automatically by
disabling any two way communication and plac-
ing the STOP/RUN-OFF switch in the OFF posi-
tion. Disconnect the high voltage source and
lockout/tagout the receptacle.
2. Using the proper size socket, slowly rotate the
crank by turning the crank pulley nut. At the
same time, use a flat, blunt object to guide the
belt off the crank pulley. Be careful not to dam-
age grooves on the pulley.
3. Replace the poly V-Belt by positioning the belt
on the water pump pulley, and while rotating the
engine (as in step 1), use a flat, blunt object to
guide the belt onto the crank pulley. Be careful
not to damage grooves on the pulley or belt.
8.5.16 Crankcase Breather
The engine uses a closed type breather with the
breather line attached to the cylinder head cover. (See
Figure 8.16)
The breather assembly should be cleaned once a year
or at every oil change interval (whichever comes first).
See Table 8–1
Figure 8.16 Engine Crankcase Breather
1. Screw
2. Breather Cover
3. Breather Valve
4. Breather Tube
Condenser coil not shown, for clarity
1
2
3
4
5
4
1
2
3

Carrier TRANSICOLD Vector 8500 Specifications

General

Brand	Carrier TRANSICOLD
Model	Vector 8500
Category	Automobile Accessories
Language	English