Carrier ChillerVu - Page 47

Configuring BACnet Device Instance and network number
Carrier® ChillerVu™
(OPN-PSM-MPCXPE) Carrier Proprietary and Confidential CARRIER CORPORATION ©2017
Installation and Start-up Guide 43 All rights reserved
7 In the
IP Address
or
Host Name
field, type the IP address of the router that functions as the BBMD (BACnet
Broadcast Management Device) for its subnet.
8 To check if the router has an existing BBMD table, click the
Broadcast Distribution Table Read
button.
9 If the
Broadcast Distribution Table
contains IP addresses that are not in your .bdt file, verify that they are
valid BBMD's and, if so, add them to your .bdt file.
NOTES
○ The BDT's in each BBMD should be identical. Repeat this entire process whenever a BBMD is added.
○ If needed, disable the checkbox next to
Show Broadcast
to limit the amount of scrolling text that is
displayed.
10 Click the
Broadcast Distribution Table
Browse
button and select the .bdt file that you made in step 4.
11 Verify that the appropriate IP address is still in the
IP Address
or
Host Name
field.
12 Click the
Broadcast Distribution Table
Write
button.
13 Click
Read
again to verify that the new .bdt file was written to the router. See example below.
NOTE
If you have a large BDT, you may have to re-size the
BBMD Configuration Tool
window to see the
Broadcast Distribution Table
.
14 Using the next IP address in the .bdt file, repeat steps 7 through 14 until every file has been updated.