Recovery
To ensure optimised working conditions, i n the following pages we are providing instructions for the overhaul control interventions,
checks and setting operations that must be performed on the engine at due planned dates.
The frequency of the maintenance operations is just an indication since the use of the engine is the main characteristic to determine
and evaluate replacements and checks.
It is not only allowed but recommended that the staff in charge of the maintenance should also car ry out the necessary maintenance
and controlling operations even if not being included in the ones listed here below but that may be suggested by common sense
and by the specific conditions in which the engine is run.
Planning of controls and periodical intervention
Contro ls and periodical inter vention
Visualcheckofengine .............................................
Check presence of water in fuel filter or pre−filter ........................
Checkofbeltwearstatus ...........................................
Checkandsettingoftappetclearance..................................
Replacementofengine’soilandfilter .................................
Replacement of fuel pre−filter........................................
Replacementoffuelfilter ...........................................
Replacementofbelt ..............................................
Daily
Daily
−
4
000
500
1000
500
1500
Frequency (hours)
!
The frequency of the maintenance oper ations is just an indication since the use of the engine is the main char acteristic
to determine and evaluate replacements and checks.
The mai ntenance oper ations are valid only if the setter fully complies with all the i nstallati on prescr ipti ons.
Furthermore , the users assembled by the setter shall always be in conformance to c ouple, power and number of turns
based on which the engine has been designed.
SECTION 3 − DUTY − INDUSTRIAL APPLIC ATION
ENGINES 93
ED. FEBUARY 2003
MAINTENANCE PLANNING
To Next Page
Loading...
