Cebora 553 - Automatic Pause Time Welding (4 T); Automatic Spot Welding (4 T); Manual Pause Time Welding (2 T); Manual Spot Welding (2 T)

64/89
5�3�5 Manual spot welding (2T)
The welding machine presets automatically for high-frequency igni-
tion (section 6)
Spot welding time activates in red, then press knob B
Set and conrm the spot welding time, then press without releasing
immediately to return to the initial welding screen, and adjust the
current.
Press the welding torch trigger and do not release it. The arc is
ignited and is shut o󰀨 automatically when the time is over.
5�3�6 Automatic spot welding (4T)
Time and current settings are the same as to 2T spot welding. Howe-
ver, in this case, the operator presses and releases the welding torch
button and awaits until the spot is done
5�3�7 Manual pause time welding (2T)
Time and current settings are the same as to 2T spot welding. Howe-
ver, in this case, the operator presses and releases the welding torch
button and awaits until the spot is done. This spot welding process
alternates working and pause times.
Widely used to obtain aesthetically pleasing welding, without defor-
ming the workpiece.
5�3�8 Automatic pause time welding (4T)
As in section 5.3.7 but with button management in 4T as in section
5.3.6