CenterLine VeriFast MicroView 1.0 - 10-port Dual Device Controller and Connection Cables

VeriFast
TM
MicroView 1.0 – User Manual – Version 1.9
13
10-port Dual Device Controller and Connection Cables
Figure 2 – Configuration of VeriFast™ MicroView 10-port Dual Device Controller
For the cables required to connect the VeriFast™ MicroView 10-port Dual Device Controller, see
Table 3 below.
Table 3 – Required connection cables for VeriFast™ MicroView 10-port Dual Device
Type of Cable
Number of Pins
Male/Female
Connection to Port
Number of Cables
M12
5-Pin or 8-Pin **
Male
Device 1 (input), Device 2 (input)
1 or 2
M12
4-Pin
Female
Power, Device 1 P2, Device 1 P1
1
M12
4-Pin
Female
Power, Device 1 P3, Device 1 P4
1
M12
4-Pin
Female
Device 2 P2, Device 2 P1
1
M12
4-Pin
Female
Device 2 P3, Device 2 P4
1
M12
4-Pin
Female
Teach Mode, Run Mode
1
M12 4-Pin Female
Device 1 Bypass,
Device 2 Bypass
1
M12
4-Pin
Female
Schedule 1, Schedule 2
1
M12
4-Pin
Female
Schedule 4, Schedule 8
1
** Depends on the configuration of the MicroView.
USB Port
HMI Display
Devices Ports* (Inputs)
Input Ports* (Digital)
Output Ports* (Digital)
* For cable requirements, see Table 3 below.