24
VeriFast
TM
MicroView 1.0 – User Manual – Version 1.9
Changing the Default Passwords
When you purchase a new VeriFast™ MicroView system, it is configured with two default
passwords to protect menus at different usage levels (user and maintenance level).
Changing both passwords during the initial setup of the MicroView
system is strongly recommended in order to improve the security and
safety of your equipment.
The two default passwords are:
• User Password: 12345
• Maintenance Password: 65500
The initial passwords provided with the unit can be quickly changed from the System Settings
screen shown on page 40. For quick access to this screen, navigate through the following screens:
Run -> Teach -> Maint Settings -> More. Whenever prompted, enter the default passwords
provided above. If more detailed instructions are needed, follow the steps provided next.
To change the User and Maintenance Passwords, do the following:
1. While in the Run Screen (illustrated on page 29), press the button on the top right side
of the screen.
2. Enter the User Password when prompted. (For default User Password see bullet above).
3. The Teach Screen (illustrated on page 31) displays. At this level of access:
• The user can teach schedules and positions, as well as name schedules;
• This screen also gives access to the Step Thru Teach Screen (illustrated on page 32).
4. While on the Teach Screen, press on button.
5. Enter the Maintenance Password when prompted. (For default maintenance password see
bullet at the top of the page).
6. The Maintenance Settings Screen (illustrated on page 34) displays. This screen provides
access to menus that allow the following:
• Change schedules tolerances;
• Perform scaling;
• Test the I/Os;
• Change operating language;
• Change measuring units;
• Set the date and time.
7. While on the Maintenance Settings Screen, press on the
button.
To Next Page
Loading...