CenterLine VeriFast MicroView 1.0 - System Settings Screen (accessible from More button)

40
VeriFast
TM
MicroView 1.0 – User Manual – Version 1.9
System Settings Screen (accessible from More button)
Figure 20 – System Settings Screen
The following areas can be identified in the System Settings screen in Figure 20.
• – Press this button to set a new User Password (see User Password section on
page 30).
• – Press this button to set a new Maintenance Password (see Maintenance
Password section on page 30).
• – Press on one of these three buttons available for each
device in order to select the component/parameter that needs to be monitored. When a
selection is made, the button turns yellow. IMPORTANT: To verify the selection, go to
the Run Screen (Figure 11 on page 29) to visualize that the correct component is
selected for each device. Depending on the selection, a maximum of two of the graphics
and monitored paramaters shown in Table 8 can be displayed:
Table 8 – Device Animation and Position Descriptions
Device
Representation /
Animation
Monitored
Position /
Parameter
Lower Electrode
Upper Electrode
Generic
Position 1
Pin Extended
Gun Opened
P1
Position 2
Weld Position
Weld Position
P2
Position 3
Pin Retracted
Double Nut
P3
Position 4
Device Enabled
Device Enabled
P4