CenterLine VeriFast MicroView 1.0 - Page 41

VeriFast
TM
MicroView 1.0 – User Manual – Version 1.9
41
• – When OFF (as shown in the image), this button indicates that the
device animation is associated from analog input '0' to '32767' (max. position). If pushed,
the button will show 'Invert Image On' and the animation direction changes from '32767'
(or max. position) to '0'. See table below.
0
32767
Invert Image Off
Invert Image On
• – Press any of these buttons to enable or disable a
device. Note: Each device connected to MicroView can be placed in ‘BYPASSED’ mode,
in which the device can be taught, but monitoring on the MicroView screen will be
disabled. An input is sent to the PLC to indicate this setting, and a “Device Bypassed”
message will be displayed on appropriate MicroView screens.
• – Press this button to return to the previous menu.